autoradio Zubehör take a look at the website. Torx motorists or bits. Pry bar or prying instrument. Wiring harness adapter.
Eliminate Any Extra Brackets. Factory automobile radios are often held in place with complex mounts, and you may or may not have to re install the bracket when you install your new radio. In the automobile pictured above, the factory stereo is connected to a huge bracket that contains a storage pocket. The mount and the space in the dash are capable of holding a much larger head unit. Since we are replacing one DIN head unit using a new single-DIN head unit, we will reuse the bracket and the storage pocket. If we had been installing a larger head unit, we would remove the pocket and possibly not use the bracket at all. If your auto has a bracket such as this, you’ll need to determine whether or not your new head unit requires it.
Car Stereo Wiring Options: Check that the Plugs. The simplest way to install a new vehicle radio is to work with a replacement head unit that is compatible with the current wiring harness plug. This limits the amount of head units you are able to use, however. In the automobile pictured above, the connector and plug clearly do not match. There are a couple unique techniques to manage this situation. The easiest method is to buy an adapter exploit. If you discover a harness that’s designed especially for your head unit and vehicle, you can simply plug it in and move. You might also have the ability to find a harness which you may wire in the pigtail that came with your head unit. The other solution is to cut the tap which was attached to your factory radio and cable the aftermarket pigtail into it. In the event you decide to go that route, you can utilize either crimp connectors or solder.