Refrigerators are not cold enough.
When your refrigerator is not cold as the set temperature, there may be some cause. Consider some easy ways to check to see why your refrigerator is not cold enough. This is quite simple and easy to ignore, so try 8 simple things below, you can get it cold again. In addition, you may wish to refer to the detailed video tutorials that will help you troubleshoot this issue.
1) Check the power plug
Every home appliance needs electricity. If everything looks unusually warm, just glance the rear of the refrigerator and confirm that the plug is still in the wall, fixed and pressed completely. Sometimes a random kick or jerk may pull the plug out, causing it to lose its connection to the grid even though it seems to be in place.
Another common mistake is moving the refrigerator thermostat. This happens when you rummage or scrape leftovers in the refrigerator. If the heat has been bumped to a higher temperature than desired, simply set it back or to set your favorite and the refrigerator will cool normally.
3) Clear the inside vent
Proper air circulation is important for refrigeration, and that means the air needs to enter the compartments as well as the back where the compressors operate.
Find the vents in both the freezer and the refrigerator to ensure that no food boxes or bags are blocking them. Try to keep these areas airy to ensure optimum performance of the refrigerator.
4) Clean the area under the cabinet
Compressors, coils and fans at the bottom of the cabinet play an important role in cooling, but they can get stuck together with everything else underneath the refrigerator. Temporarily switch off the fridge and dust off these parts to increase efficiency. Do not forget to turn on the fridge when you are done.
5) Clean and inspect the door gaskets
Refrigerators are based on rubber door pads, the inside of the refrigerator and the freezer door to keep cool from being exposed to the outside. Otherwise, all its cooling efforts will leak into the house instead of keeping the food cold.
The pad may be warped, dirty, moldy due to excessive moisture or damage. If you see signs of damage, you should replace them. If not, simply wipe it with diluted bleach solution.
6) Make more room in the fridge
Refrigerators need space to allow cold air to move around the dish. For this reason, if you arrange your refrigerator too hermetically by the food boxes, the whole setup may be difficult when chilling. Make sure that about two thirds of the actual refrigerator space (usually on the shelves) is ventilated for air circulation.
7) Remove the ventilation holes for the refrigerator
One of the ways that refrigerator manufacturers improve their own efficiency is to use some cold from the freezer to cool the refrigerator. This is done through the vent, if the freezer is closed and the snow enters the vent which prevents the cooler from blowing. If your refrigerator has these vents, position them and make sure they do not have ice.
8) Check the cabinet door carefully
Finally, most smart refrigerators stop positive cooling when the door is opened to maintain efficiency. By using a push button when the door is closed and jumping when the door is open. If the refrigerator door switch breaks down, mua diều hòa cũ the refrigerator may not be switched back to the cooler. You can check by pressing the switch with the door open to see if the lights are off or not.
If you find that you need to replace the refrigerator or have other errors that can not be checked, call the hotline 0975159046 for 24-hour support.